Rudder stop fine tuning

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
senaka
Posts: 57
Joined: Wed 10. May 2023 9:36:53
Location: The Netherlands

Did a test flight after upgrading to v4. All was perfect except that I noticed that if I do a fast rudder movement and center the stick. The tail continues to move and I need to apply opposite rudder to stop the rotation. Do I need to decrease the rudder stop parameter from the default 6?
The model is SAB Kraken 580. Thanks
Top
ZeXx86
Site Admin
Posts: 12782
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

I guess there is something unusual in the settings
Could you share settings file? I will check the parameters.
Maybe there is Rudder - Stop Smoothing value. Default is 0.
Spirit System developer
Top
senaka
Posts: 57
Joined: Wed 10. May 2023 9:36:53
Location: The Netherlands

kraken580.4ds
(255 Bytes) Downloaded 1877 times
Attached is the configuration, I did readjust the rudder end limits after the upgrade from ver3.7.2 to ver4.0.0

Thanks for checking.
Top
senaka
Posts: 57
Joined: Wed 10. May 2023 9:36:53
Location: The Netherlands

The issue isn’t reproducible anymore which is great. The only change is I reduced the stop a and b from the default value 6 to 5. Not sure if a higher value contributed to this unexpected behavior I experienced. Rudder stop smoothing is unchanged at 0. I’ll share the log’s if it reoccurs again.
Top
Post Reply

Return to “Support”