Wave with rx7 receiver

[jonbrum]

So I am just making my first foray into fixed wing as I normally fly Helis. I have a basic trainer with 2 ailerons and flaps. I have bound the Wave to the RX7, elevator and rudder are fine, flaps fine but I am only getting 1 aileron working, I have them plugged in to channels 2and 3 on then RX7, channel 3 appears to be responding but nothing from channel 2, tried reversing and nothing so I have no idea. Also have no throttle, esc just beeps so no idea what’s going on there also.

[Habásek]

You need to set the output to ch2 in Channels in Wave - now Spirit telemetry will be there.
Or put the second aileron on ch 5/6/7 ... as needed

[jonbrum]

Can’t get this to work at all, o well back to Vbar then, shame really I quite like the Wave but a serious lack of information on how to set up even a basic model.

[ZeXx86]

You only have to set output to Servo at CH2. Model - Receiver - Output Mapping menu (second page)
Takes just 10 seconds.

Default output settings is for Spirit RX protocol. Good idea, we can make it automatic in next update.

[jonbrum]

Managed to get it sorted, thanks for you help on that. I recalibrated the throttle, that was also showing unassigned in the receiver channels, but I have that working now.