RX7 or µRX connected to W1

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Sepp62
Posts: 45
Joined: Sat 07. Feb 2015 22:14:51

The manual shows a configuration, where a RX7 is connected to a W1 unit:

https://manual.spirit-system.com/index. ... _RX_Wiring

Is this configuration meant for a backup receiver configuration? If yes: Does it already work or is it something for the future?
Top
ZeXx86
Site Admin
Posts: 12887
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

This configuration is meant for doing firmware update.
However same wiring will be used as Backup in near future - for now setup as a Backup receiver is not supported, but firmware update will add this.
Spirit System developer
Top
Post Reply

Return to “Support”