[SOLVED] After update to 4.0.3 I have connection issue

[IFHELI]

After updating software I went to update my Spirit GT and it will connect to the computer now. I went back to 4.0.2r2 and it still will not connect. I then tried another SGT I have and it will not connected. I have tried several USB dongles and still no luck.

[ZeXx86]

Can you check Status LED after power up?
If unit has pulsating LED light you will need to perform recovery flashing.

[IFHELI]

The LED is solid blue. These two Spirit GT have sat all winter in the house. Today was the first time to try connecting to computer in about five months.

[IFHELI]

I pulled out my old and really slow laptop with Windows 10 on it and I was able to update 2 Spirit GT and one Spirit II to 4.0.3. I had no connection issue with this computer. I still have a connection issue with my laptop using windows11. It is not seeing the interface.

[ZeXx86]

I am afraid there is no relation to 4.0.3 update. It could be because of missing USB driver in your computer. You can try to launch it as Administrator.

[IFHELI]

I have no problem with Rotorflight or Brain2 / Ikon connecting to this computer. I load the drivers each time I update the Spirit software. This is the first time I have ever had this problem. I`m not sure where else to look. Everything appears to be up to date on drivers. I have even tried going back to 3.7.0 and no luck.

[ZeXx86]

The problem could actually happen when other FBL software is rewriting drivers for own.

[IFHELI]

ZeXx86,

Good new, I launch it as Administrator and it did not work. I then tried again and it worked. Now I can open and connect normally without "launch it as Administrator".

[ZeXx86]

Maybe some other FBL software was using the same port. I think rotorflight or brain software could grab it for itself.