Hi,
Whenever I use Spirit Wave with Spirit W3, always BEC voltage is 0v from telemetry.
I updated to latest firmware of Wave, W3, and ESC. all same. even hobbywing v5 and Scorpion TribunusIII ESC. Except BEC voltage, other telemetry values are shown well.
Is it normal?
it's the other issue.
I'm using Scorpion Tribunus III 06 160A ESC with the latest firmware, on Spirit Wave it's not possible to connect ESC configuration. There was no problem to access Hobbywing ESC configuration on Wave radion meanwhile.
Is it also normal?
Spirit System
Support forum