No connection after setting failsafe

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
aziz76
Posts: 24
Joined: Thu 07. May 2015 10:49:20

I was setting up a new Spirit GTR unit on a heli and i had just completed setting up all the parameters, level swash, limits etc. I then set the fail safe condition by pressing set fail safe. The unit rebooted and since then has failed to connect to the software and also the radio even though the receiver is bound and i can even see the EX telemetry sensor that is connected. Power cycling the unit, the status light keeps on flashing and it never initializes.

Would appreciate any help.

Thanks

Abdulaziz
Top
Post Reply

Return to “Support”