I have a Spirit RS3 ( intern jeti receiver) and Geolink V2.
I want to connect a second jeti Rex3 receiver and a R900NG receiver.
How must I connect and in wich port must I connect them?
Desmond
Spirit RS3 and Jeti
Hello,
it has to be connected at the E1 port. From then you will see this receiver in the Device Explorer.
Make sure that E1 port is still configured as JETI EXBUS. Not JETIBOX/Sensor.
it has to be connected at the E1 port. From then you will see this receiver in the Device Explorer.
Make sure that E1 port is still configured as JETI EXBUS. Not JETIBOX/Sensor.
Spirit System developer
-
Jetnerd Belgium
- Posts: 3
- Joined: Fri 02. Oct 2026 18:02:00
So the rex 3 must be connected to the E1 port with the JST-RX adapter cable.
I asume the Geolink to the E2 port. Where does the R900NG receiver go in ?
Desmond
I asume the Geolink to the E2 port. Where does the R900NG receiver go in ?
Desmond
Unfortunately connecting third JETI receiver is not supported.
Nothing can be connected at the E2 pin otherwise main receiver connection will be lost.
GeoLink is always connected at the SAT2 port.
Nothing can be connected at the E2 pin otherwise main receiver connection will be lost.
GeoLink is always connected at the SAT2 port.
Spirit System developer