Jeti and Spirit 3 channel assignment/ unable to assign channel 8 in Spirit Settings SW

[ste]

Jeti DS-14 connected with EX-Bus to Spirit 3
All configurations done with Windows Spirit Settings V4.0.5

With the help of Spirit Settings I've assigned 7 channels (list is not in the assgnment order) :

• Throttle

• Tail

• Pitch

• Nick

• Roll

• Gyro sensitivity

• Rescue

So far so good.
No I would like to add bank switching, to have on Bank 0 the manual throttle (its a Nitro) and on Bank 1 the rpm control.

BUT: The Spirit Settings does only provide the possibilty to select Channels 1..7 which are already used. There is no selection possibility for a channel number above 7 which would be needed for the bank switching.

I'm confused:

• Is my Transmitter setting wrong, and maybe the Bank Channel is not yet send to the Spirit?

• Or is there a bug in the Software?

• Or ist there something else (maybe me) which causes the issue?

Any help is appreciated.

May you have a gentle landing...

[Phil S.]

Did you create an appropriate channel on your TX under "MENU - Model - Functions Assignment" already?
Regards Philipp

[ZeXx86]

Hello,

unfortunately channel assignment is probably not correct, all channels 1 - 6 should be unchanged at both sides in JETI and Spirit. It is enough to create Spirit model in your radio - this will create channel layout that will simply work out of the box that will simply work.
Then you can assign Channel 7 to Bank Switching. This is normal way how JETI users are doing it.