Question on setup - Graupner SUMD

[Laterne_13]

Hello,
i´m just setting up my first Spirit in connection with a Graupner GR16 Receiver (Sumd).

In the the diagnostic-tab or in the "setup with wizard" where i had to adjust the end-points to be +/- 100%, i had to change the endpoints in my transmitter to +/-85 that the values in the diagnostic-tab are +/- 100.
I think thats very inaccourate and i am not sure, if this is all right.
In comparison to a vstabi with GR16 (sumd), i hadn´t adjust the end-points in the transmitter. The minimum and maximum are equal and exactly +/- 100.

[ZeXx86]

Hello,

this is very correct. Each controller has its own ranges, with digital protocols there is very high precision.

[Laterne_13]

Many thanks for the fast and competent help. Now I can complete the setup!