Forza Ex & Spirit problems

[Rocky77]

Hi,
I installed spirit fbl on my Forza Ex and I have a problem with the min max cyclic pitch.

If I adjust the min to - 12°, the Max is 8°

I checked the 0°, the calibration stick +/-100% is correct.

How can I do to be symetric?

Thanks and sorry for my bad English

[ZeXx86]

Hi,

first from all I recommend to check, if you are getting 0° angle on the blades when you enable Subtrim (tuning).
In this case, it is necessary that servo horns are at 90°, perpendicular do push rods.

In some cases it is really not possible to configure equal throw for both sides, so you have to use Servo Travel Correction (Servos tab).

[Rocky77]

The 2 first step are OK, so I will try to use servo tab tonight. I use the mks92A+
Thanks for your quick response

[Rocky77]

OK, the use of the servo tab solved my first problem. Thanks

I finished the tune of the Spirit but now I have a new problem.
When I move the cyclic ring with the pitch stick and I stop it, , the cyclic ring oscillate fast, and it doesn't stop to oscillate even with the cyclic gain at min.
I have the 6° at 82. I don't know if it could be the problem. :/

[ZeXx86]

What do you mean with Cyclic Ring? Is it Cyclic Ring - Aileron / Elevator Range in the software?

Could you attach your settings here?

[Rocky77]

Sorry, by Cyclic Ring, I mean swashplate.

Now, I just power on my Forza, and I do not have the swash plate that oscillates when I move the pitch stick

Here is my settings

[ZeXx86]

Good,
maybe your collective pitch was out of range - more than 100% in the diagnostics tab. If you have changed this then it is OK now.

[Rocky77]

First test flight. Whaoo, amazing! The feeling is better than my old beastX.
And the management of the rudder excellent!
I think I will have fun this weekend! [emoji2]

[ZeXx86]

Great. For the rudder, I recommend to increase maybe Piro Consistency parameter little bit higher (155 - 160) if your tail is not holding perfectly.

[Rocky77]

OK, thanks for your advice