Issue with Jeti Device Explorer

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
Eury
Posts: 17
Joined: Tue 28. Apr 2015 19:36:27

I've been loving my Spirits with the Jeti integration. However, I've noticed an issue. When I go into the section where you can choose the bank to program, and choose the option to change banks from the transmitter, it jumps out of the Spirit setup and goes back to Device explorer where Spirit is listed with an X next to it and won't let me do anymore adjustments. It stays locked out until I power cycle the Spirit.

The same thing happens on both of my Helis that are setup with the Spirit, so it is not one unit. They are both running the newest 1.1.0 firmware, although I'd love to say they were running something newer with governor support!
Top
ZeXx86
Site Admin
Posts: 12831
Joined: Mon 29. Apr 2013 16:06:44
Contact:
Contact ZeXx86

Hello,

this is correct. This is because when bank is switched
You only have to press refresh button in your transmitter or to wait few seconds.
Spirit System developer
Top
Post Reply

Return to “Support”