Spirit System

Yes, that is fine.

Well, before shipping each module is tested if it is working properly. The only thing that has to be done is to plug one cable at the SYS and other at any free port in the unit or receiver. For example AUX1/AUX2/CH0.

The problems all started after I did a bec test. After that finished the wifi module disconnected from the spirit and never worked again.

The esc is a HW 50a v3 set to 7.2v bec, powering 4x kst 215mg servos.

Ah, I am afraid that sending the module to us is needed. It looks like something was damaged during the event.