Hello!
Please can you give me the exact connection with the DS16, Spirit and R9 say?
I do not get out've tried everything.
But why does it work in my diabolo with the RSat2 ...?
Thank You!
Jeti DS16, R9 Receiver and Spirit...?
Connection for UDI is:
SAT (RX) <-> RUD (Unit)
This is for R9 EX.
Is your receiver R9 or R9 EX?
In the unit you have to configure SRXL/SUMD and save.
In the receiver UDI serial connection must be selected.
After battery reconnect all should work.
SAT (RX) <-> RUD (Unit)
This is for R9 EX.
Is your receiver R9 or R9 EX?
In the unit you have to configure SRXL/SUMD and save.
In the receiver UDI serial connection must be selected.
After battery reconnect all should work.
Spirit System developer
So,
have div. Set possibilities tries out.
I had properly put transmitter and receiver already at the beginning.
Now I have laid an extra electricity supply to the receiver.
Now it functions!!!
Switch on only extra electricity supply, then stick on accumulator. Now everything Correctly initializes!
Before I had the light "Servo-Rattle noise " and only after everlasting seconds he has initialized.
Have you experienced already similar behaviour?
Greeting Frank
have div. Set possibilities tries out.
I had properly put transmitter and receiver already at the beginning.
Now I have laid an extra electricity supply to the receiver.
Now it functions!!!
Switch on only extra electricity supply, then stick on accumulator. Now everything Correctly initializes!
Before I had the light "Servo-Rattle noise " and only after everlasting seconds he has initialized.
Have you experienced already similar behaviour?
Greeting Frank