Page 2 of 2
Re: Model oscillates in elevator and aileron axes with Spiri
Posted: Thu 12. Aug 2021 10:46:56
by weixelgeist
ZeXx86 wrote:Value for Geometry 6° is still looking very high.
Is the model after crash or was it flying perfectly previously?
Is RPM low or normal flying RPM for such helicopter?
The model is brand new, no crash. RPM is 1870 RPM, that is normal for the LOGO 550SE.
I am flying very smooth scale style, no 3D
I am back from the field and I got empirically following settings:
Geometry is at 3,5 ° the value is at 70
Nick Filter is at 3
With this settings the oscillation is almost gone.
Re: Model oscillates in elevator and aileron axes with Spiri
Posted: Thu 12. Aug 2021 10:49:14
by ZeXx86
Can you please share your settings file?
Re: Model oscillates in elevator and aileron axes with Spiri
Posted: Thu 12. Aug 2021 11:11:20
by weixelgeist
The settings file
Re: Model oscillates in elevator and aileron axes with Spiri
Posted: Thu 12. Aug 2021 14:33:31
by weixelgeist
If I change over to the Spirit2 would I have the same problems?
Re: Model oscillates in elevator and aileron axes with Spiri
Posted: Sun 05. Sep 2021 20:38:07
by Jay23
Ive had this problem, one of your servos isnt centered properly, dont rely on the spirit setup wizard to centre your servos, you need a dedicated servo tester/center, they arn't expensive i think i got mine from Amazon.