Spirit System

ZeXx86 wrote:We have implemented this feature for demand of the pilots so you do not need to use any sequencers now.
If you are beginner then you can save the helicopter faster and at the same it will recover to the normal position.

Sorry, but may be that a beginner will try inverted flight with a safe altitude, so no need to climb during 1,5 s before recovering the héli ? At worst, the heli will be too high during the recovery, and a beginner may lose the orientation of his heli, especially with small heli like 450.

Il you want to try inverted flight near to the ground, rescue in acro mode is better.

It is constructive criticism, not denigration !

+1 for a submenu in which we can trim the time before recovering from inverted to skid down.

Garfield wrote:+1 for a submenu in which we can trim the time before recovering from inverted to skid down.

Oh yes, +1 here too

Yes, we will add new parameter to the settings so it can be configured.

ZeXx86 wrote:Yes, we will add new parameter to the settings so it can be configured.

+1

Did two packs today with the new firmware.
I can understand the idea why this is done.
The guys with programmable radios can change behaviour how they want.
However if it's fixed in Spirit firmware, users can not.

For small helis 0 (=old style) or 0.5 Seconds would be perfect.
Otherwise they are sky high before the skids are down.
Not something beginners would like.

I hope this small change can be done quickly with for example v1.3.1 firmware.

Thanks!

icare wrote: Sorry, but may be that a beginner will try inverted flight with a safe altitude, so no need to climb during 1,5 s before recovering the héli ? At worst, the heli will be too high during the recovery, and a beginner may lose the orientation of his heli, especially with small heli like 450.

Il you want to try inverted flight near to the ground, rescue in acro mode is better.

It is constructive criticism, not denigration !

That's me, except I am practising inverted with an even smaller heli - a 300 size.

Thank you Tomas for making the change.

+1 for a submenu in which we can trim the time before recovering from inverted to skid down.

We have released 1.3.1 right now, where you can configure this exactly as you wish.

ZeXx86 wrote:We have released 1.3.1 right now, where you can configure this exactly as you wish.

Already done ????


I downloaded the 1.3.1 software and went to the stabi page to see if it was true... (sorry... ) and yes, there is a new setting between 0 and 3 s now

Thank you very much !