Page 2 of 3
Re: 1.3.1 failure
Posted: Thu 15. Oct 2015 16:26:15
by Rcpassa
What Do I do next?
Re: 1.3.1 failure
Posted: Thu 15. Oct 2015 17:00:23
by ZeXx86
When your LED blinks for a while, then only you have to do is:
1. Start the software and then press No when prompted to Demo mode.
2. Select the firmware in the Update tab and press the flash button (you should see Recovery mode label immediately).
3. Connect the battery to your model (with USB interface connected). Then you should see a new flashing progress.
Re: 1.3.1 failure
Posted: Thu 15. Oct 2015 18:04:15
by Rcpassa
If it doesn't, what should I do?
Re: 1.3.1 failure
Posted: Thu 15. Oct 2015 20:45:19
by Rcpassa
It does not blink...what do I do??? This is getting frustrating.
Re: 1.3.1 failure
Posted: Thu 15. Oct 2015 20:47:47
by ZeXx86
It is not a problem. I will send you the guide in the private message.
Re: 1.3.1 failure
Posted: Thu 15. Oct 2015 20:56:41
by Rcpassa
Did you send it?
Re: 1.3.1 failure
Posted: Thu 15. Oct 2015 20:57:29
by ZeXx86
Yes.
Re: 1.3.1 failure
Posted: Thu 15. Oct 2015 20:58:58
by Rcpassa
Pls check your pm...
Re: 1.3.1 failure
Posted: Thu 15. Oct 2015 21:19:14
by Rcpassa
How long should the recovery take?
Re: 1.3.1 failure
Posted: Thu 15. Oct 2015 21:20:31
by Rcpassa
Once the unit is plugged in?