Spirit System

Tail servo is 620 should i use 333h?

Yes, 333Hz is good for this servo.

Rudder Delay should be at 10 to achieve better results.

You were correct by setting the rudder latency to 10 jn the servo to 300hz made the diference.

I got a very very small tail move and imidiate recovery on very hard pitch ups and down

Thanks guys, great support and unit

Perfect,

you are welcome!

ZeXx86 wrote:Perfect,

you are welcome!

Yeap tweaked settings a little more and tail is solid rock no matter what. Only issue now is that when i hit rescue the heli is not going straight up. I checked the swash is level and the heli is initializing on flat surface

Anything else to try?

datamedic wrote:Only issue now is that when i hit rescue the heli is not going straight up. I checked the swash is level and the heli is initializing on flat surface

Anything else to try?

How many degrees of error?

Can you tell me which firmware version do you have and if you are moving with the helicopter after initialization? (before flight).

hello

i have the latest firmware

i have tryed both 1)power up and flight imidietly after init without moving the heli and 2) power up , let it init on the table and move it to flight sight 10 feet away for flight

How many degrees of error?

i would say about 10 to 15