Spirit System

Fortune7 wrote:

ZeXx86 wrote:Probably serial port you selected is not correct one or there is loose connection somewhere.
Spirit unit is used only for powering.
Power supply must be same for Wifi-Link and Spirit unit.

OK, thanks, Tomas - I'll check again.

Cheers, Andy

If your module was not updated to 3.0.0 then this is not fix for you.

Hi,

OK, I had success now repairing the WiFi-Link following the instructions.
Must have been some connection-fault, after reconnecting it worked!
Now I was able to flash version 3.1.
I just need to reconfigure the WiFi-Link again.

Thanks a lot, now I can flash the other one also.

Regards,
Alexander

Fortune7: Do you think you are able to measure resistance of the resistors?
Are you powering Wifi-Link and Spirit unit from the same power supply (BEC/battery)?

ajadda: You are welcome!

ZeXx86 wrote:Fortune7: Do you think you are able to measure resistance of the resistors?
Are you powering Wifi-Link and Spirit unit from the same power supply (BEC/battery)?

OK, Tomas, my mistake was to power the Wifi adapter from a separate 2S battery. Now, with it connected to the BEC / Spirit supply, it works fine.

So sorry to bother you with this dumb mistake - you are very busy and you don't need idiots taking up your time!

Great Customer Service, as always!

Many thanks, Andy

I was able to fix the module using the pdf procedure now is at v3.1
next things to do is to remove the two resistors ... will do in the next days

thanks a lot Thomas

today i did the resistor removal and short
and can confirm all works correctly on spirit2 too

thanks Tomas