Spirit System

Hi, I have the feeling that in Servo Travel Correction the Maximum and the Minimum are swapped.
My non-zero values are for low stick but they appear here in the first part, the Maximum area. I think they should be shown below in the Minimum area.

One other small thing... with 2.0.0 the Failsafe information can be saved to the unit (for some receiver typoes), but I don't see it here in the printed settings detail. Would be nice to have.

Hi,

thank you for the report.
This issue is caused because of your special firmware where it must be swapped because of your rotor head.
So it is not officially supported yet.