Spirit System

Hello everyone I have setup my Oxy 3 Qube main and tail with the spirit fbl and I have a little tail kick and the p gain and revo-mix is at the limit

Pgain at the max before tail hunting

So what can I do now or what is the problem to much pitch maybe for a 3 blade?

Best regards Joeri

Verstuurd vanaf mijn SM-N910F met Tapatalk

Increase your piro consistency. You shouldn't need any revo mix. I was having the same issue and just upped the piro consistency parameter and was all gone on my 450L

You'll probably need to drop the p gain a bit as well.

Ok thanks I try that and lower the revo-mix again then?

Verstuurd vanaf mijn SM-N910F met Tapatalk

Yeap you shouldn't need any revo mix

jgiannakas wrote:Yeap you shouldn't need any revo mix

Thanks for the tip man that's works great! I only have tail wag now... And before not :/

Best regards Joeri

Verstuurd vanaf mijn SM-N910F met Tapatalk

Joeri_Plees wrote:

jgiannakas wrote:Yeap you shouldn't need any revo mix

Thanks for the tip man that's works great! I only have tail wag now... And before not :/

Best regards Joeri

Verstuurd vanaf mijn SM-N910F met Tapatalk

Drop your tail gain. Also what is your rudder delay value? What pirouette consistency did you end up with?

I go to the field tomorrow hopefully and test it with lower tail gain.. And let you now the value of the consistency

Verstuurd vanaf mijn SM-N910F met Tapatalk

Joeri_Plees wrote:I go to the field tomorrow hopefully and test it with lower tail gain.. And let you now the value of the consistency

Verstuurd vanaf mijn SM-N910F met Tapatalk

Thanks! Ive noticed that now that I've setup my governor to hold rpm more aggressively I have a minor kick when doing pitch pumps. Running 175 piro consistency on my 450L. Possibly need to up even more on my side or add 1 or 2 points of revo mix. Will be trying it at the field next time as well

You will always get a small kick with agressive govs. Tune it out with revo too much and other things become worse. Side tick tocs to name one.