Page 1 of 1
Rudder delay setting
Posted: Tue 19. Jul 2016 23:10:19
by Helibelly
Hi, I was wondering what would be a good number to set the rudder delay to on my trex 450. I am using a JR ds290g tail servo. The speed is 0.07 seconds. It is currently set to 10.
Thanks, Eric.
Re: Rudder delay setting
Posted: Wed 20. Jul 2016 8:22:53
by thestructured
Try it at 5 or 6. Basically, lower it until the tail stops feeling loose and laggy.
Re: Rudder delay setting
Posted: Wed 20. Jul 2016 15:26:43
by Helibelly
thestructured wrote:Try it at 5 or 6. Basically, lower it until the tail stops feeling loose and laggy.
OK will try that so, thanks