Page 1 of 1
[SOLVED] Spirit has no pitch function after updates to 2.0.1
Posted: Sat 20. Aug 2016 1:51:29
by berley114
i have just installed my unused spirit on a new heli, firmware was at v1.0.25. and so i performed the firmware update.
I updated from v1.0.25 to v1.3.2 then on to v2.0.1, Rudder & Cyclic work fine but, i have no pitch function. The spirit diagnostics & Tx monitor indicate the THR & Pitch working fine but the servos do not move.
Thanks for any help.
Kim.
Re: Spirit has no pitch function after firmware updates to 2
Posted: Sat 20. Aug 2016 4:55:06
by FrankFuss
Make sure that your Rudder Gain is positive, if not, pitch output might be fixed if Rescue is enabled.
Re: Spirit has no pitch function after firmware updates to 2
Posted: Sat 20. Aug 2016 9:48:25
by berley114
Thanks for your reply, bailout not enabled at this time. i will try to flash to a previous firmware or even reset to factory settings if its possible.
Re: Spirit has no pitch function after firmware updates to 2
Posted: Sat 20. Aug 2016 12:07:00
by ZeXx86
Hello,
Factory reset will be the best. Please try to set Stabi/Function to Disabled. If it will help, then the rescue was engaged all the time.
Re: Spirit has no pitch function after firmware updates to 2
Posted: Sat 20. Aug 2016 15:17:45
by berley114
Finally ive managed to get it sorted, i flashed back to v1.3.2 which actually made things worse, i had no servo functions at all apart from the servos moving from the sensors, I decided to try a re flash of the v2.0.1, after a re boot everything is now working as it should. Goblin setup is almost complete just the bailout to do.
Thanks for help & suggestions.
Re: Spirit has no pitch function after firmware updates to 2
Posted: Sat 20. Aug 2016 17:10:13
by jgiannakas
Why are you not using the latest FW? 2.02 I believe?