Spirit System

What to say : it's just great and deserves congratulations, really. My sole advice would be to add in the manual that you have to look at the 3rd page in the telemetry/.../Gene menu before reaching the SPIRIT settings menu which is not that obvious at the first glance.

The rest is really convenient, particularly the actual rotor RMP while flying, even out of the governor mode. Many thanks and looking forward to seeing further improvments.

Rgds

Thank you very much!

We are always very klad for such kind words.
Also thank you for the tip.

+ 1
This update is truly incredible.
A huge thanks to you Thomas, and to all the team.

The Update is really great. But ich have one issue with telemetrie. My spirit is on GAM. But i can enter programming on each way (GAM, EAM, GPS, VARIO) on my mz 24.
Because of this issue my graupner t45 esc is no more reacheable in telemetrie programming.
Is Thais a known issue?
Greetings Andreas

Thank you!

Windsurfer1976: No this was not known issue. We will verify it. What if you will change Spirit to EAM? You can do so directly in the integration - Advanced/Expert settings.

I think it was the same ad i tried yesterday. I will check it again tonight to verify it.
Sender is mz-24 receiver gr - 16

Sorry for the spelling. German autocorrection...

Same Problem with Spirit and Unisens E (configured aß ESC). I can only reach the Spirit Setup.

This is interesting, because TomasN is running Unisens-E and Spirit together with apparently no issue.
So maybe there is something that is doing the problem.

Can you try to reconfigure Unisens-E to EAM?

Just checked it again. The same issue if i change to EAM. It responds on all sensors (GAM, VARIO, GPS) but ESC not reachable...


If i change to EAM and run my unilog2 on GAM no response of the unilog2 too