Spirit System

Hi,

I'm using a Spirit Pro (FW 2.31) in a HD 750 helicopter.

By hoovering the helicopter and controlling short elevator inputs, the helicopter
is a little bit swinging before stopping. By controling short aileron inputs,
the stopping behavior is very good.

During the flight all is fine, the problem is only by hoovering and short elevator inputs.

Is there a parameter to optimize this behavior ?

Thanks and best regrds,
Dirk

Hi,

increase Advanced/Elevator Filter to 3, maybe 4 if needed. Then it should be fine.

Thanks, I'll try.


Best regards,
Dirk

Setting the Elevator Filter from 2 to 3 works fine.


Thanks and best regards,
Dirk