Tail servo end points
Posted: Thu 01. Jun 2017 0:50:16
I am setting up my first Spirit Pro and have intergration with my DS-16.
While checking everything, I found that my tail wasn't going to it's furthest travel.
I went into Device Manager and found the the servo travel was set to 85%.
So I changed the travel to 100% in both directions. I saw the servo adjusting as I did this.
I the repowered the heli and tried the tail again, but there didn't appear to be any change.
I went back into Device Manager, and found that the new setting had been saved.
I have only checked this on the work bench, not in flight.
Am I misisng something.
While checking everything, I found that my tail wasn't going to it's furthest travel.
I went into Device Manager and found the the servo travel was set to 85%.
So I changed the travel to 100% in both directions. I saw the servo adjusting as I did this.
I the repowered the heli and tried the tail again, but there didn't appear to be any change.
I went back into Device Manager, and found that the new setting had been saved.
I have only checked this on the work bench, not in flight.
Am I misisng something.