Page 1 of 2
Lost Model Alarm (LMA)
Posted: Tue 10. Oct 2017 22:16:37
by jjuk
Please design, manufacture and sell a really loud LMA that can be triggered from an unused channel.
Or from a selected spare channel if using sbus.
Sell for about $10
Thanks.
Re: Lost Model Alarm (LMA)
Posted: Wed 11. Oct 2017 21:50:29
by Coco66
This works fantastic at USD 7.99
http://www.lostmodelalarm.com
Lost Model Alarm (LMA)
Posted: Thu 12. Oct 2017 5:52:20
by pachy
Thanks for this link !
Just we need the Spirit can have one more channel, like the spirit pro...
Re: Lost Model Alarm (LMA)
Posted: Sat 14. Oct 2017 22:18:25
by jjuk
$14 delivery!
Re: Lost Model Alarm (LMA)
Posted: Sun 22. Oct 2017 16:29:21
by jjuk
Is it possible to pass though a sbus channel signal to a spare servo port on the spirit ?
I can then connect that channel to a buzzer.
Re: Lost Model Alarm (LMA)
Posted: Mon 23. Oct 2017 7:05:47
by ZeXx86
Hello.
Yes, with Spirit Pro it is possible - F: Output to CH0
But usually you can do so also with a Futaba receiver. If it is 4 channel receiver, you can program it to output higher set of channels instead of channels 1, 2, 3..
Re: Lost Model Alarm (LMA)
Posted: Thu 26. Oct 2017 18:46:47
by jjuk
I don't have the pro, I have 2x red spirits. Is it possible with these?
Re: Lost Model Alarm (LMA)
Posted: Thu 26. Oct 2017 20:33:48
by ZeXx86
With non-Pro you have to use a receiver with a free receiver port.
Re: Lost Model Alarm (LMA)
Posted: Thu 26. Oct 2017 20:46:08
by jjuk
Can't. Using FrSky xsr
Re: Lost Model Alarm (LMA)
Posted: Thu 26. Oct 2017 21:08:36
by Coco66
Guys, for the passive one you don't need a dedicated channel. Use a Y with any servo, say, rudder, and the thingy will start shouting after one minute without a change in the signal or signal loss. Very practical.