Spirit System

Hi

here is a log of current in A for my diabolo. You can see that current in A freeze at the last value registered when I cut off the motor after few minutes.
Then when I start the motor again, the value is reset to the correct value. I don't know if it is a kontonik or a spirit telemetry bug ? (jive pro, spirit pro and jeti DS 14, no Telme). It is not very important, as consumed current is not affected.

Hi,

this is "normal" behavior of Kontronik ESCs. But we can fix it in our unit
In next update it will be OK.

Thank you for the message.

What can I say ??? Thank you for your support !