Castle esc setting up

[Martind]

Hi everyone I’ve been having trouble trying to setup the end points on my ice 50a esc via the spirit. I can get it set on the rx (frsky xr4sb) on ch3 but as soon as it in the fbl unit it get no signal? The hw was fine.

[ZeXx86]

You only have to proceed according the manual.

Please see this page:
http://manual.spirit-system.com/index.p ... Castle_ESC

If it will not work, then please try to decrease Throttle Min. range down to 1040us.

This should help.