Spirit System

Hi there.

Just got my spirit pro installed and config, i have a spektrum receiver connected to the primary satellite port but when i connect the Geolink to the secondary sat port nothing happens.
If i connect it to the primary port nothing happens and if i connect the receiver to the secondary port it doesn't recognize it :/

Thinking of just using the Spirit pro as a gyro and throw the geolink away.

What do you mean by Nothing happens?

Did you enabled the GeoLink support in the Spirit Settings and saved the settings?
Each module is tested before shipping so it is working for sure. You have to proceed according the GeoLink manual strictly.

Please see this page:
http://manual.spirit-system.com/index.p ... ing#Wiring

Now its solved, it didnt lid up or reach the settings.

But i just tried to connect it several times and then suddenly it worked.


Skickat från min iPhone med Tapatalk