Spirit System

Hello Tomas,
I would like to use a Tail-Servo (760µs/333-560Hz) as Govenor-Servo for my Nitro-Heli.
Is there a way to change this in the Govenor-Settings?
But I guess without a new firmware it's not possible?
Are you planing to make a new firmware?
Best whishes,
Robert

not sure will make any difference
maybe nitro engine is not able to follow a servo so fast

Hello,

you can use only 1520µs servos for Throttle.

In the future 760µs is planned.

Thanks so much for your prompt reply
Greets , Robert

Hello,
Today I tested the Graupner Servo 770 HBS as a Govenor-Servo in my Goblin 650 Nitro.
The servo runs with 1520μs and is actually intended as a rear servo.
I was really surprised how fast and well the Govenor works now.
Throttle response is prompt and the rpm is fantastic stable.
I think a 760μs servo will work even better, and I hope there will be soon a
new soft,-and firmware, so I can use a fast tail servo

Thank you for the message!

Yes, the support will be included soon. But 760us are not always faster than 1520us. But usually just tail servos are 760us.