Page 1 of 1

Stabilization inverted

Posted: Thu 20. Nov 2014 21:02:21
by Jman841
I would like to set up my failsafes to activate a bank so that Stabilization mode is activated with the collective pitch at 0 degree's to hopefully reduce crash damage in case of a lost link and the failsafes are activated.

What I am concerned about is if this happens while I am flying inverted. With stabilization mode will the heli remain inverted or will it turn upright like Normal rescue mode?

I would like for if a crash to happen, it to land on the skids so it can take the initial blow of impact and hopefully cause less damage.

Re: Stabilization inverted

Posted: Thu 20. Nov 2014 21:07:05
by ZeXx86
Hi

With Stabilisation mode your helicopter will remain in the position which is closer. So it can eventually fall on the head.

Re: Stabilization inverted

Posted: Thu 20. Nov 2014 21:55:17
by Jman841
Hmm, that is not good. Any way a future update could include upright only stabilization mode for this purpose?

Re: Stabilization inverted

Posted: Thu 20. Nov 2014 22:02:42
by ZeXx86
Yes, it is very likely.