Spirit System

Hi
I converted a Trex 150 to a μSpirit.
I am very happy with it
I can adjust everything with my DS 16
only my tail rotor swings but not always only sometimes.
can someone share settings with me?



Thomas

is there anybody who can help ????
Do this or that ....

Yes, but you are asking for somebody with T-Rex 150.
We have no T-Rex 150, but to resolve tail issues you have to change Advanced/Pirouette Consistency parameter.

Thank you!
I will test later

I'm already at the value of 130
I can not go lower
When I put it up, it starts to swing heavily
Is there still a possibility?

Thank you for your help

Yes, you can change Rudder Delay. First try to set 0. Then try to set 25. Probably increasing Rudder frequency to a higher can help a lot too.

between 0 and 30 no differences

In this case please decrease Gyro Gain until there are no oscillations and set Advanced/Rudder Revomix to 3-4. This might help a lot.

The Rudder Gain was already at 5% have it set to 0
And Revomix was already at 4 I changed to 3
No difference

This is very low value. What will happen if you will set Gyro Gain to 40%?

We can prepare special firmware where Pirouette Consistency can have half effect. Hopefully it will help.