Spirit System

Dear Spirit Developer,
I have a question regarding the Jeti Integration Menu.
(Spirit 2 unit, Firmware 2.7.1, Tx dc-14 , RX Rex 3)
In General -> Channel Assignment there are only channels
Gas - 1, Gyro - 5 and FStabiFunction - 7 shown. (see picture)
Do I have something configured wrong ?
Otherwise anything works Ok.
Kind regards,
Robert

Hello,

this is OK, because there is no reason to change other channel 2,3,4 and 6 with the EX Bus connection.
But for special functions you can configure up to 16th channel.

Thank you very much for your fast reply.
Good to know anything is OK.
Greetings from germany,
Robert