Add info to tail end point setting instructions
Posted: Sat 28. Dec 2019 21:49:51
Hi Tomas
Could you please add instructions to the manual and software help box about setting the rudder end points such as max and min settings (70-170) instead of just the max range available
E.G. if upper limit (170) is reached then move servo ball out (arm too short ) and if lower limit is reached (70) move servo ball in (arm too long)
Regards
Andy
Could you please add instructions to the manual and software help box about setting the rudder end points such as max and min settings (70-170) instead of just the max range available
E.G. if upper limit (170) is reached then move servo ball out (arm too short ) and if lower limit is reached (70) move servo ball in (arm too long)
Regards
Andy