Spirit System

Hi can someone put a link of a holder for Geolink for My Oxy 3,to be printed in 3d? I ask why on thingiverse, I found only one, but it does not seem accurate,
attached I inserted the only model that I found on thingiverse, did someone print it? is it accurate?
Thanks

Hi

i have solved

Online on thingiverse I didn't like the one for Oxy 3..one cable tie to fix it, then I printed the one for Oxy2(The best) and I had to slightly modify it,because the diameter of tail boom of the oxy 2 is 2 mm lower than that of the Oxy3, u can see in attachment photo

Thanks