Spirit System

I received the unit and started the setup.
Not clear from the integration chapter, where does the ESC go... Does it go into ch1?
And about Banks, what wire goes into this?

Hope someone can help
Thanks

Hello,

ESC will be connected at the AUX1 port.
Did you read the manual or checked the Setup Wizard embedded in the software?
It is all described there.

For example here is description in the manual:
http://manual.spirit-system.com/index.p ... TOR_WIRING

ZeXx86 wrote:Hello,

ESC will be connected at the AUX1 port.
Did you read the manual or checked the Setup Wizard embedded in the software?
It is all described there.

For example here is description in the manual:
http://manual.spirit-system.com/index.p ... TOR_WIRING

In that section of the manual it says :
In the Spirit unit - AUX (AUX1) port (Failsafe is handled by unit and/or additionally by receiver)

AND, a few lines below that it says inside the blue frame:
By default Throttle output from the unit is disabled for all receiver types (except Spektrum DSM2/X). Assign Channel 1 in the General/Channels - Throttle.

So, you can see why am I confused...

Cheers

P.S - I also DID NOT get an email notification on the response here, why? Am I posting my queris and missing out something? I am always ticking the box "Notify me when a reply is posted"

OT

if you want in the user control panel there is one setting to have the
"Notify me when a reply is posted" always selected

/OT