Page 1 of 1
can't get spirit2 to operate after attempt to flash 3.2
Posted: Wed 21. Oct 2020 10:52:49
by mb-1953
I have many units and in the process of updating, 1 of them didn't reboot at the end and wont respond. I tried recovery several times, the blue light flashes but when done there is no response. Does it need to be sent back? or am I missing something?
Re: can't get spirit2 to operate after attempt to flash 3.2
Posted: Wed 21. Oct 2020 10:59:02
by ZeXx86
Hello,
sorry for the troubles. The recovery process is working normally, am I right?
Will the firmware bootup in the end, at least immediately after flashing?
Very likely sending is not needed. It can be resolved remotely.
Re: can't get spirit2 to operate after attempt to flash 3.2
Posted: Wed 21. Oct 2020 23:58:09
by mb-1953
Tried recovery with geolink disconnected and it recovered. all good now.