Spirit System

Hi,

So I finally got to fully go and test this system and I love it. I need to fine tune it a bit more but hey. So my issue is I powered up my 500 and I got no movements in the servos at all had to unplug the lipo. When I got home I wanted to check what the logs said so I clicked into it but then the application crashed. When I started the application again it only showed me the logs from from the moment I powered up again. Is there anyway to get the old logs back?

Hi,

the issue is very likely related to this:
https://www.spirit-system.com/phpBB3/vi ... =20&t=4761

Can you share your settings file please?
It would be helpful to know what receiver are you using?

I am using a AR6610T 6 Channel DSMX Telemetry Receiver : SPMAR6610T