Cyclic gain from TX

In case you do not know something or you are not sure, here is the right place for your question.
Post Reply
latjo-k
Posts: 131
Joined: Fri 06. Dec 2019 8:22:54

Hi
I have done a new funktion in my jetiTX called gyro cyclic connected to flight mode sw and set P7 as trim pot.Then connected it to channel 9.
And in menu finetuning,function curves gyro cyclic i have set constant gain valus for my cyclic gains FMode norm 1 2,and in Spirit settings channelmapping i chose cyclic gain ch 9.
In the same window i can se the values send from TXand i can adjust them whith P7+-,the values looks OK.
Now my question,the values in channelmapping window is not the same as shown in sensor tab cyclic gain,the values in sensor tab changes when i changes
flightmode but they arent the same as in channel mapping window,if i turn the P7 nothing happens to gain value,whitch one shows the right values,channelmapping or sensortab?
Can someone explain this for me?
(Unit Spirit GTR)
MVH
Lars
Top
Post Reply

Return to “Support”