Spirit System

Hi guys.

Got a Raptor 90 3D set up with a Spirit GT. Yeah I know, old meets new...

The aileron and elevator throws at max stick are different to each side, left and right are different and forward and backwards are different.
Is there a way to adjust the endpoints in the Spirit GT? Haven't found a way to achieve this.

I take it adjusting this in the radio is a big no-no?


Cheers.

I get the same problem with 4 different Helis.
All of them got a GT unit.
This is while on the ground.

When you get airborne, you actually fly the FBL unit and not the helicopter.
So when you apply full stick, you actully tell the FBL to go at maximum rate it was set to and the FBL should roll/flip the heli in equal rates for both directions.

In my case,
On the ground I get assymetrical cyclic pitch but in flight it performs good.

Check it in flight.

Cheers


Sent from my Redmi Note 8 Pro using Tapatalk

Thanks for the quick reply Lee

I didn't think of that, at all.... But makes perfect sense.
First time with a FBL, so many old habits are still stuck...
Will check it next time at the field.

Thanks a lot!

Cheers.