Spirit System

I tried connecting SRXL from AR9020 to Spirit on the RUD port and set config to SRXL. I then did a power cycle and went to the diag screen. Moving my Tx does adjust the values, but everything is acting crazy. I'm getting values well outside -100 and +100 (over 200) and channels will wildly bounce around (not a few points around 0, but 30, 40, +)

Has SRXL Spektrum support been tested?

Didn't notice Baedarlboo started topic asking same question.

Look forward to SRXL support in future update (hope it's in the next one!)