Spirit System

Hi there, I have tried to find info about the laser on Geolink v2 - obviously it is below the device, where the golden pattern is in the little box on one side, right? Is it's direction 90° from the devices box to the ground?

If I create my own mount with my 3D printer, do I have to make sure, that the way to the ground is free - so nothing is covering this part of the device? How do you do that with the big tail boom of a Kraken 580 - now way can this laser have visivble sight to ground, if mounted on top.

I'm just collecting ideas to solve this - if the laser is really needed - is it?

A lot of questions for which I haven't found any answers yet.

Thanks for your hints,
Oliver

It not must be all the time on the boom!

madman wrote:Hi there, I have tried to find info about the laser on Geolink v2 - obviously it is below the device, where the golden pattern is in the little box on one side, right? Is it's direction 90° from the devices box to the ground?

If I create my own mount with my 3D printer, do I have to make sure, that the way to the ground is free - so nothing is covering this part of the device? How do you do that with the big tail boom of a Kraken 580 - now way can this laser have visivble sight to ground, if mounted on top.

I'm just collecting ideas to solve this - if the laser is really needed - is it?

A lot of questions for which I haven't found any answers yet.

Thanks for your hints,
Oliver