Spirit System

Hello, just installed the new FW 3.42 looks good will Test this weekend, also I don't see the update for the GeiLonk V2 ?

Is the new Geolink Firmware 1.3.1 only for V2 or also V1?

Updated to Spirit 3.4.2 today, but there is no Geolink Update...

As you can see in the ChangeLog there is only update for GeoLink v2.

ZeXx86 wrote:As you can see in the ChangeLog there is only update for GeoLink v2.

Sorry didn’t saw that, thank you Tomas

Thanks
Tino

Moin,just updated all, I noticed that I'm on the first floor around 3 M, and the GeoLink shows -0.1M?
Is this intentioned ? For security reasons?

ZeXx86 wrote:As you can see in the ChangeLog there is only update for GeoLink v2.

What do you mean you are not able to open it?
There is nothing to open, only click at the Flash button.
Many users already updated GeoLink v2.

Have done, it is necesary erase all the first Software 3.41.

ZeXx86 wrote:What do you mean you are not able to open it?
There is nothing to open, only click at the Flash button.
Many users already updated GeoLink v2.

Hello, should you even install FW 3.42 if you only use Geolink v.1?

Hello,

if you want to use new features from 3.4.2 then it is good to update

Ok thanks, will update it.