Spirit System

V1 or V2 (1.3.0 or 1.3.1)
When I calibrate the compass it always takes 3 times
Apply power , move helicopter around, invert , move more … remove power… repeat 2 more times before green led on V2 won’t light and the blue led comes on after gps lock

Is this normal ?

Thanks

This unfortunately mean that the compass calibration was never finished. After 3 tries it will return to original calibration.

The Status LED must be flashing periodically when it is finished.

I found a YouTube video
Paint a sphere
Nose north

What indication shows it has completed calibration
For v2 and v1

Thanks

When Calibration is finished then the Status LED will be flashing periodically even when there is no movement.
And it will flash until you will plug battery off.

Thanks...

Needed to be more patient.

Changes from GREEN to blinking BLUE once done