Spirit System

This evening i tested new geolink V2. FW 1.3.1.
Z axis very bad. By altitude holld, altitude limit and rth the heli jumps up and down. Not able to fly with this functions.
Dieter

Hello,

can you send your settings please?
Also any detail about your helicopter would be very useful.

GeoLink firmware 1.3.1 is not changing behavior at all. It is same as 1.3.0 in terms of control of the model.
There were only small changes in functions such as Position Hold, Return to Home and Geo-fence with Spirit firmware 3.4.2.
But altitude is unaffected, same as older version 3.4.1, 3.4.0, ..

This thread is missing any subject description, so I will update it for better orientation.

Thank you for quick Answer. Hell acrobat se Plöchinger, last week with geolink v1 all o.k. I will send my settings tomorrow..
Dieter

Today a new test. i only changed rescue pitch from 55 to 60%. It was much better than yesterday. Ar next i decrease altitude sensivity to 60%. I have mounted panel for geolink with two brass screws? Is that one problem?
Dieter