Spirit System

Every time I need to get my DX9 setup with a new model - I have to F..K around with the reversing on the TX and Spirit before the swash is moving correctly.

This is such a BS problem, there must be a step-by-step "how-to" explanation of getting this resolved. Does anyone have a link to something helpful or an explanation of the process of elimination.

The manual seems useless for this.

Thank you,

Hello,

there are only two steps that you have to do in regards to reversing.

1. Reverse radio channels according Diagnostic tab/Setup wizard and from then never touch these reverses.
2. Reverse servos in the Servos tab/Setup wizard to achieve correct movements. It is enough to move with pitch stick up and down and reverse all servos that are moving in a wrong direction.

Then you are done.

If you are using a digital channel transmission protocol such as Spektrum DSM2/X or SRXL2 (no PWM or PPM) then point 1 will be correct out of the box. So then no reversing in your radio is needed at all.

In other words it is enough to proceed according Setup Wizard.

Thank you. Re-doing the Wizard made this easy.