Geo link V2 altitude limits

In case you would like to see some new feature in the software you can share it right here!
You can also report issue or odd behavior here.
Post Reply
pb3d
Posts: 7
Joined: Sat 19. Feb 2022 11:47:54

Hi,

I am struggling to set the lower altitude limit with geo link V2 firmware 1.3.1. It was working fine when a dedicated channel was assigned, and the calculated height was displayed at the geo link tab.

Now I have set the altitude limit to be activated by the stabi channel (values +100 and -100). The manual says that the lower limit will be calculated, but I can only see that the function is active when I use the stabi (set as coaxial).

Any ideas how to resolve this matter?

Thanks
PB
Top
Post Reply

Return to “Wishlist / Bug report”