Spirit System

Hi guys

Today, I did my first maiden flight with a new heli (DIABOLO SE) with my first Spirit GT FBL on board.
So far everything went fine except, that used capacity shows ten times too low.

RPM, voltage and current values are accurate.
Attached a short log.
I-motor-shunt does not allow the required correction. Any suggestions are welcome!

Thanks in advance and best regards
Daniel

BTW: Great FBL, I love it!

Update

In contrast to the Futaba-Log in initial post, which states the real value for current (A), Spirit-Log shows current divided by 10.
See attachement.

Thanks for your support!

Best regards
Daniel

Hello,

thank you for your message.
We found the issue few days ago with some HW v5 ESCs and it was already fixed.
New firmware will be available possibly in next week. Or if you wish it sooner, we can send it to you.

Hello

Great, I will keep an eye for the updates.
Thanks a lot!

Daniel

Hello

Could you provide the estimated release date of the update, which will solve this issue?

Thanks
Daniel

We can make available the update to you immediately.
Official release date could be during 2 weeks.

Hello

Two weeks (more or less ) will be fine!
I'm gona wait for this official release, thanks!

best regards
Daniel