Spirit Software Load Problem

[Harleyflyer1000]

I have a Spirit 2 that I installed on a Goblin 280 Havok. I previously went through all the setup process. It’s been a few weeks and I tried last week to start the Spirit software but it would not load on my Dell laptop. It would just say scanning for devices and it would never boot up further. This occurred whether I was trying to go in Demo mode with no connection and also when I had the 280 powered and initialized before I loaded the Spirit software. I didn’t have time to deal with it last week and I just tried again today and I am encountering the same problem.

I also uninstalled the Spirit software and downloaded it again just to make sure my original file was not corrupted in some way.

Anyone have any ideas on what my problem might be?

[ZeXx86]

Please take a look here:
http://manual.spirit-system.com/index.p ... es_message

Usually it is enough to turn off Bluetooth in your computer.

[Harleyflyer1000]

I did get it to work on my desktop and it worked fine. I will give the Bluetooth tip a try on my laptop.

Thanks for the feedback.