Spirit System

I am using a Spirit GT, Jeti DS-12 (Spirit version) Tx with a Jeti Duplex REX3 receiver. The receiver is connected to the Spirit unit via the E2 port. I have followed the instructions in the Spirit System Manual - Jeti Integration section 9 on Telemetry Data. The only Telemetry variables displayed after carrying out the Auto scan are S Vibes, S RPM and S Altitude. I want to access S Voltage (Main battery voltage) S Capacity (Main Battery consumed capacity). The Heli is fitted with a Hobbywing Platinum 60A ESC. Can someone tell me how to do this please.
Many thanks

How do you have the ESC telemetry connected and set up?

The HW 60A ESC does not have a current sensor, so you won’t get either current (Amps) or mah consumption (capacity) using this ESC.

Hello,
look here for more information...
https://manual.spirit-system.com/index. ... _Telemetry

Regards

He should see at least battery voltage which the 60A provides.

Thank you all for your replies. I understand completely that I have missed out the ESC connection. I will examine the link and resolve this and advise further. Thank you all again.

I have installed the Telem UNI cable and can now access telemetry data. Thank you again